17 area virtual-link dead-interval (ospf), 18 area virtual-link hello-interval (ospf), 19 area virtual-link retransmit-interval (ospf) – Kontron AT8902 Full Size CLI User Manual
Page 141

AT8901/2/3
Page 3 - 29
AT8901/2/3 CLI Reference Manual
3.7.17
area virtual-link dead-interval (OSPF)
This command configures the dead interval for the OSPF virtual interface on the
virtual interface identified by
<areaid>
and
<neighbor>.
The
<neighbor>
parameter
is the Router ID of the neighbor. The range for seconds is 1 to 65535.
Default
40
Format
area
Mode
Router OSPF Config
3.7.17.1
no area virtual-link dead-interval
This command configures the default dead interval for the OSPF virtual interface on
the virtual interface identified by
<areaid>
and
<neighbor>
. The
<neighbor>
parameter is the Router ID of the neighbor.
Format
no area
Mode
Router OSPF Config
3.7.18
area virtual-link hello-interval (OSPF)
This command configures the hello interval for the OSPF virtual interface on the
virtual interface identified by
<areaid>
and
<neighbor>
. The
<neighbor>
parameter
is the Router ID of the neighbor. The range for
<seconds>
is 1 to 65535.
Default
10
Format
area
65535>
Mode
Router OSPF Config
3.7.18.1
no area virtual-link hello-interval
This command configures the default hello interval for the OSPF virtual interface on
the virtual interface identified by
<areaid>
and
<neighbor>
. The
<neighbor>
parameter is the Router ID of the neighbor.
Format
no area <areaid> virtual-link <neighbor> hello-interval
Mode
Router OSPF Config
3.7.19
area virtual-link retransmit-interval (OSPF)
This command configures the retransmit interval for the OSPF virtual interface on the
virtual interface identified by
and
. The
parameter
is the Router ID of the neighbor. The range for seconds is 0 to 3600.
Default
5
Format
area <areaid> virtual-link <neighbor> retransmit-inter-
val <seconds>
Mode
Router OSPF Config