11 show arp brief, 12 show arp switch, 2 ip routing commands – Kontron AT8902 Full Size CLI User Manual
Page 118: 11 show arp brief - 6, 12 show arp switch - 6, 2 ip routing commands - 6

AT8901/2/3
AT8901/2/3 CLI Reference Manual
Page 3 - 6
Type
Is the type that was configured into the unit. The possible values are
Local, Gateway, Dynamic and Static.
Age
This field displays the current age of the ARP entry since last refresh
(in hh:mm:ss format
3.1.11
show arp brief
This command displays the brief Address Resolution Protocol (ARP) table
information.
Format
show arp brief
Mode
Privileged EXEC
Age Time (seconds) Is the time it takes for an ARP entry to age out. This value was
configured into the unit. Age time is measured in seconds.
Response Time (seconds) Is the time it takes for an ARP request timeout. This value
was configured into the unit. Response time is measured in seconds.
Retries
Is the maximum number of times an ARP request is retried. This value
was configured into the unit.
Cache Size
Is the maximum number of entries in the ARP table. This value was
configured into the unit.
Dynamic Renew Mode Displays whether the ARP component automatically attempts
to renew dynamic ARP entries when they age out.
Total Entry Count Current / Peak Field listing the total entries in the ARP table and
the peak entry count in the ARP table.
Static Entry Count Current / Max Field listing the static entry count in the ARP
table and maximum static entry count in the ARP table.
3.1.12
show arp switch
This command displays the contents of the switch’s Address Resolution Protocol
(ARP) table.
Format
show arp switch
Mode
Privileged EXEC
IP Address
Is the IP address of a device on a subnet attached to the switch.
MAC Address Is the hardware MAC address of that device.
Interface
Is the routing slot/port associated with the device’s ARP entry.
3.2
IP Routing Commands
This section describes the commands you use to enable and configure IP routing on the
switch.