Kontron AT8902 Full Size CLI - Manual (Page 160)

AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 3 - 48
3.8.6 default-metric (RIP)
This command is used to set a default for the metric of distributed routes.
Format
default-metric <0-15>
Mode Router RIP Config
3.8.6.1 no default-metric (RIP)
This command is used to reset the default metric of distributed routes to its default
value.
Format
no default-metric
Mode Router RIP Config
3.8.7 distance rip
This command sets the route preference value of RIP in the router. Lower route
preference values are preferred when determining the best route. A route with a
preference of 255 cannot be used to forward traffic.
Default 15
Format distance rip <1-255>
Mode Router RIP Config
3.8.7.1 no distance rip
This command sets the default route preference value of RIP in the router.
Format
no distance rip
Mode Router RIP Config
3.8.8 distribute-list out (RIP)
This command is used to specify the access list to filter routes received from the source
protocol.
Default 0
Format distribute-list <1-199> out {ospf | static | connected}
Mode Router RIP Config
3.8.8.1 no distribute-list out
This command is used to specify the access list to filter routes received from the source
protocol.
Format
no distribute-list <1-199> out {ospf | static | connected}
Mode Router RIP Config
3.8.9 ip rip authentication
This command sets the RIP Version 2 Authentication Type and Key for the specified
interface. The value of <
type
> is either
none
,
simple
, or
encrypt
. The value for