9 show logging buffered, 10 show logging hosts, 11 show logging traplogs – Kontron AT8902 Full Size CLI User Manual
Page 219: Show logging buffered - 23

AT8901/2/3
Page 5 - 23
AT8901/2/3 CLI Reference Manual
5.5.9
show logging buffered
This command displays buffered logging (system startup and system operation logs).
Format
show logging buffered
Mode
Privileged EXEC
Buffered (In-Memory) Logging Shows whether the In-Memory log is enabled or
disabled.
Buffered Logging Wrapping Behavior The behavior of the In Memory log when
faced with a log full situation.
Buffered Log Count The count of valid entries in the buffered log.
5.5.10
show logging hosts
This command displays all configured logging hosts.
Format
show logging hosts
Mode
Privileged EXEC
Host Index
(Used for deleting hosts)
IP Address
IP address of the logging host.
Severity Level The minimum severity to log to the specified address. The possible
values are emergency (0), alert (1), critical (2), error (3), warning (4),
notice (5), info (6), or debug (7).
Port
Displays the server port number, which is the port on the local host
from which syslog messages are sent.
Host Status
The state of logging to configured syslog hosts. If the status is disable,
no logging occurs.
5.5.11
show logging traplogs
This command displays SNMP trap events and statistics.
Format
show logging traplogs
Mode
Privileged EXEC
Number of Traps Since Last Reset Shows the number of traps since the last boot.
Trap Log Capacity Shows the number of traps the system can retain.
Number of Traps Since Log Last Viewed Shows the number of new traps since the
command was last executed.
Log
Shows the log number.
System Time Up Shows how long the system had been running at the time the trap
was sent.
Trap
Shows the text of the trap message.