Kontron AT8902 Full Size CLI - Manual (Page 147)

AT8901/2/3
Page 3 - 35 AT8901/2/3 CLI Reference Manual
Mode Interface Config
3.7.34 ip ospf transmit-delay
This command sets the OSPF Transit Delay for the specified interface.
The transmit delay is specified in seconds. In addition, it sets the esti-
mated number of seconds it takes to transmit a link state update packet
over this interface. Valid values for
range from 1 to 3600
(1 hour).
Default 1
Format
ip ospf transmit-delay <1-3600>
Mode Interface Config
3.7.34.1 no ip ospf transmit-delay
This command sets the default OSPF Transit Delay for the specified interface.
Format
no ip ospf transmit-delay
Mode Interface Config
3.7.35 ip ospf mtu-ignore
This command disables OSPF maximum transmission unit (MTU) mismatch detection.
OSPF Database Description packets specify the size of the largest IP packet that can be
sent without fragmentation on the interface. When a router receives a Database
Description packet, it examines the MTU advertised by the neighbor. By default, if the
MTU is larger than the router can accept, the Database Description packet is rejected
and the OSPF adjacency is not established.
Default enabled
Format ip ospf mtu-ignore
Mode Interface Config
3.7.35.1 no ip ospf mtu-ignore
This command enables the OSPF MTU mismatch detection.
Format
no ip ospf mtu-ignore
Mode Interface Config
3.7.36 router-id (OSPF)
This command sets a 4-digit dotted-decimal number uniquely identifying the router
ospf id. The <
ipaddress
> is a configured value.
Format
router-id
Mode Router OSPF Config
3.7.37 redistribute (OSPF)
This command configures OSPF protocol to allow redistribution of routes from the
specified source protocol/routers.