beautypg.com

24 show trapflags, 7 cli command logging command, 1 logging cli-command – Kontron AT8902 Full Size CLI User Manual

Page 264: 24 show trapflags - 24, 7 cli command logging command - 24, Logging cli-command - 24

background image

Management Commands

AT8901/2/3

AT8901/2/3 CLI Reference Manual

Page 6 - 24

6.6.24

show trapflags

This command displays trap conditions. Configure which traps the switch should
generate by enabling or disabling the trap condition. If a trap condition is enabled and
the condition is detected, the SNMP agent on the switch sends the trap to all enabled
trap receivers. You do not have to reset the switch to implement the changes. Cold and
warm start traps are always generated and cannot be disabled.

Format

show trapflags

Mode

Privileged EXEC

Authentication Flag Can be enabled or disabled. The factory default is enabled.

Indicates whether authentication failure traps will be sent.

Link Up/Down Flag Can be enabled or disabled. The factory default is enabled.

Indicates whether link status traps will be sent.

Multiple Users Flag Can be enabled or disabled. The factory default is enabled.

Indicates whether a trap will be sent when the same user ID is logged
into the switch more than once at the same time (either through Telnet
or the serial port).

Spanning Tree Flag Can be enabled or disabled. The factory default is enabled.

Indicates whether spanning tree traps are sent.

Broadcast Storm Flag Can be enabled or disabled. The factory default is enabled.

Indicates whether broadcast storm traps are sent.

ACL Traps May be enabled or disabled. The factory default is disabled. Indicates

whether ACL traps are sent.

DVMRP Traps Can be enabled or disabled. The factory default is disabled. Indicates

whether DVMRP traps are sent.

OSPF Traps Can be enabled or disabled. The factory default is disabled. Indicates

whether OSPF traps are sent.

PIM Traps

Can be enabled or disabled. The factory default is disabled. Indicates
whether PIM traps are sent.

6.7

CLI Command Logging Command

This section describes the commands you use to configure CLI Command Logging.

6.7.1

logging cli-command

This command enables the CLI command logging feature, which enables the
FASTPATH software to log all CLI commands issued on the system.

Default

enabled

Format

logging cli-command

Mode

Global Config

6.7.1.1

no logging cli-command

This command disables the CLI command Logging feature.