Kontron AT8902 Full Size CLI - Manual (Page 245)

AT8901/2/3 Management Commands
Page 6 - 5 AT8901/2/3 CLI Reference Manual
6.1.9 show serviceport
This command displays service port configuration information.
Format
show serviceport
Mode Privileged EXEC
IP Address The IP address of the interface. The factory default value is 0.0.0.0
Subnet Mask The IP subnet mask for this interface. The factory default value is
0.0.0.0
Default Gateway The default gateway for this IP interface. The factory default
value is 0.0.0.0
ServPort Configuration Protocol Current Indicates what network protocol was
used on the last, or current power-up cycle, if any.
Burned in MAC Address The burned in MAC address used for in-band connectiv-
ity.
6.2 Console Port Access Commands
This section describes the commands you use to configure the console port. You can
use a serial cable to connect a management host directly to the console port of the
switch.
6.2.1 configuration
This command gives you access to the Global Config mode. From the Global Config
mode, you can configure a variety of system settings, including user accounts. From
the Global Config mode, you can enter other command modes, including Line Config
mode.
Format
configuration
Mode Privileged EXEC
6.2.2 lineconfig
This command gives you access to the Line Config mode, which allows you to
configure various Telnet settings and the console port.
Format
lineconfig
Mode Global Config
6.2.3 serial baudrate
This command specifies the communication rate of the terminal interface. The
supported rates are 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.
Default 9600
Format
serial baudrate {1200 | 2400 | 4800 | 9600 | 19200 | 38400
| 57600 | 115200}
Mode Line Config