beautypg.com

6 show loginsession, 7 show users, Show loginsession - 15 – Kontron AT8902 Full Size CLI User Manual

Page 255: Show users - 15

background image

AT8901/2/3

Management Commands

Page 6 - 15

AT8901/2/3 CLI Reference Manual

If you select

des

, you can specify the required key on the command line. The

encryption key

must be 8 to 64 characters long. If you select the

des

protocol but do

not provide a key, the user is prompted for the key. When you use the

des

protocol, the

login password is also used as the snmpv3 encryption password, so it must be a
minimum of eight characters. If you select

none

, you do not need to provide a key.

The

value is the login user name associated with the specified encryption.

You must enter the

in the same case you used when you added the user.

To see the case of the

, enter the

show users

command.

Default

no encryption

Format

users snmpv3 encryption {none | des[key]}

Mode

Global Config

6.5.5.1

no users snmpv3 encryption

This command sets the encryption protocol to none. The

is the login user

name for which the specified encryption protocol will be used.

Format

no users snmpv3 encryption

Mode

Global Config

6.5.6

show loginsession

This command displays current Telnet and serial port connections to the switch.

Format

show loginsession

Mode

Privileged EXEC

ID

Login Session ID

User Name The name the user will use to login using the serial port or Telnet.
Connection From IP address of the Telnet client machine or EIA-232 for the serial

port connection.

Idle Time

Time this session has been idle.

Session Time Total time this session has been connected.

6.5.7

show users

This command displays the configured user names and their settings. This command is
only available for users with Read/Write privileges.

The SNMPv3 fields will only be displayed

if SNMP is available on the system.

Format

show users

Mode

Privileged EXEC

User Name The name the user enters to login using the serial port, Telnet or Web.
Access Mode Shows whether the user is able to change parameters on the switch

(Read/Write) or is only able to view them (Read Only). As a factory
default, the “admin” user has Read/Write access and the “guest” has
Read Only access. There can only be one Read/Write user and up to
five Read Only users.