Kontron AT8902 Full Size CLI - Manual (Page 262)

Management Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 6 - 22
Format
snmptrap mode
Mode Global Config
6.6.18.1 no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are inactive (not able
to receive traps).
Format
no snmptrap mode
Mode Global Config
6.6.19 snmp trap link-status
This command enables link status traps by interface.
NOTE: This command is valid only when the Link Up/Down Flag is enabled.
“snmp-server enable traps linkmode” on page 6 - 20.
Format
snmp trap link-status
Mode Interface Config
6.6.19.1 no snmp trap link-status
This command disables link status traps by interface.
NOTE: This command is valid only when the Link Up/Down Flag is enabled.
See 6.6.12 “snmp-server enable traps linkmode” on page 6 - 20).
Format
no snmp trap link-status
Mode Interface Config
6.6.20 snmp trap link-status all
This command enables link status traps for all interfaces.
NOTE: This command is valid only when the Link Up/Down Flag is enabled.
See 6.6.12 “snmp-server enable traps linkmode” on page 6 - 20
Format
snmp trap link-status all
Mode Global Config
6.6.20.1 no snmp trap link-status all
This command disables link status traps for all interfaces.
NOTE: This command is valid only when the Link Up/Down Flag is enabled.
See 6.6.12 “snmp-server enable traps linkmode” on page 6 - 20
Format
no snmp trap link-status all
Mode Global Config
6.6.21 show snmpbind
This command displays the port the SNMP server is binded to.