Kontron AT8902 Full Size CLI - Manual (Page 162)

AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 3 - 50
3.8.11.1 no ip rip send version
This command configures the interface to allow RIP control packets of the default
version to be sent.
Format no ip rip send version
Mode Interface Config
3.8.12 hostroutesaccept
This command enables the RIP hostroutesaccept mode.
Default enabled
Format
hostroutesaccept
Mode Router RIP Config
3.8.12.1 no hostroutesaccept
This command disables the RIP hostroutesaccept mode.
Format
no hostroutesaccept
Mode Router RIP Config
3.8.13 split-horizon
This command sets the RIP split horizon mode. Split horizon is a technique for
avoiding problems caused by including routes in updates sent to the router from which
the route was originally learned. The options are: None - no special processing for this
case. Simple - a route will not be included in updates sent to the router from which it
was learned. Poisoned reverse - a route will be included in updates sent to the router
from which it was learned, but the metric will be set to infinity.
Default simple
Format split-horizon {none | simple | poison}
Mode Router RIP Config
3.8.13.1 no split-horizon
This command sets the default RIP split horizon mode.
Format
no split-horizon
Mode Router RIP Config
3.8.14 redistribute (RIP)
This command configures RIP protocol to redistribute routes from the specified source
protocol/routers. There are five possible match options. When you submit the
command redistribute ospf match the match-type or types specified are
added to any match types presently being redistributed. Internal routes are redistributed
by default.
Default metric—not-configured
match—internal