Kontron AT8902 Full Size CLI - Manual (Page 150)

AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 3 - 38
Metric Shows the metric for the advertised default routes. If the metric is not
configured, this field is blank.
Metric Type Shows whether the routes are External Type 1 or External Type 2.
Maximum Paths Shows the maximum number of paths that OSPF can report for a
given destination.
Redistributing This field is a heading and appears only if you configure the system to
take routes learned from a non-OSPF source and advertise them to its
peers.
Source Shows source protocol/routes that are being redistributed. Possible
values are static, connected or RIP.
Metric Shows the metric of the routes being redistributed.
Metric Type Shows whether the routes are External Type 1 or External Type 2.
Tag
Shows the decimal value attached to each external route.
Subnets For redistributing routes into OSPF, the scope of redistribution for the
specified protocol.
Distribute-List Shows the access list used to filter redistributed routes.
3.7.42 show ip ospf area
This command displays information about the area. The <
areaid
> identifies the OSPF
area that is being displayed.
Format show ip ospf area
Modes Privileged EXEC
User EXEC
AreaID Is the area id of the requested OSPF area.
External Routing Is a number representing the external routing capabilities for this
area.
Spf Runs Is the number of times that the intra-area route table has been calcu-
lated using this area's link-state database.
Area Border Router Count The total number of area border routers reachable within
this area.
Area LSA Count Total number of link-state advertisements in this area's link-state
database, excluding AS External LSA's.
Area LSA Checksum A number representing the Area LSA Checksum for the speci-
fied AreaID excluding the external (LS type 5) link-state advertise-
ments.
Import Summary LSAs Shows whether to import summary LSAs.
OSPF Stub Metric Value Shows the metric value of the stub area. This field displays
only if the area is a configured as a stub area.
The following OSPF NSSA specific information displays only if the area is configured
as an NSSA.
Import Summary LSAs Shows whether to import summary LSAs into the NSSA.