beautypg.com

3 telnet commands, 1 ip telnet server enable, 2 telnet – Kontron AT8902 Full Size CLI User Manual

Page 247: 3 transport input telnet, 3 telnet commands - 7, Ip telnet server enable - 7, Telnet - 7, Transport input telnet - 7

background image

AT8901/2/3

Management Commands

Page 6 - 7

AT8901/2/3 CLI Reference Manual

6.3

Telnet Commands

This section describes the commands you use to configure and view Telnet settings.
You can use Telnet to manage the device from a remote management host.

6.3.1

ip telnet server enable

Use this command to enable Telnet connections to the system and to enable the Telnet
Server Admin Mode. This command opens the Telnet listening port.

Default

enabled

Format

ip telnet server enable

Mode

Privileged EXEC

6.3.1.1

no ip telnet server enable

Use this command to disable Telnet access to the system and to disable the Telnet
Server Admin Mode. This command closes the Telnet listening port and disconnects
all open Telnet sessions.

Format

no ip telnet server enable

Mode

Privileged EXEC

6.3.2

telnet

This command establishes a new outbound Telnet connection to a remote host. The
host value must be a valid IP address. Valid values for port should be a valid decimal
integer in the range of 0 to 65535, where the default value is 23. If [debug] is used, the
current Telnet options enabled is displayed. The optional line parameter sets the
outbound Telnet operational mode as ‘linemode’, where by default, the operational
mode is ‘character mode’. The noecho option disables local echo.

Format

telnet [debug] [line] [noecho]

Modes

Privileged EXEC
User EXEC

6.3.3

transport input telnet

This command regulates new Telnet sessions. If enabled, new Telnet sessions can be
established until there are no more sessions available. An established session remains
active until the session is ended or an abnormal network error ends the session.

NOTE: If the Telnet Server Admin Mode is disabled, Telnet sessions cannot

be established. Use the

ip telnet server enable

command to

enable Telnet Server Admin Mode.

Default

enabled

Format

transport input telnet

Mode

Line Config