4 transport output telnet, 5 session-limit, 6 session-timeout – Kontron AT8902 Full Size CLI User Manual
Page 248: Transport output telnet - 8, Session-limit - 8, Session-timeout - 8

Management Commands
AT8901/2/3
AT8901/2/3 CLI Reference Manual
Page 6 - 8
6.3.3.1
no transport input telnet
Use this command to prevent new Telnet sessions from being established.
Format
no transport input telnet
Mode
Line Config
6.3.4
transport output telnet
This command regulates new outbound Telnet connections. If enabled, new outbound
Telnet sessions can be established until the system reaches the maximum number of
simultaneous outbound Telnet sessions allowed. An established session remains active
until the session is ended or an abnormal network error ends it.
Default
enabled
Format
transport output telnet
Mode
Line Config
6.3.4.1
no transport output telnet
Use this command to prevent new outbound Telnet connection from being established.
Format
no transport output telnet
Mode
Line Config
6.3.5
session-limit
This command specifies the maximum number of simultaneous outbound Telnet
sessions. A value of 0 indicates that no outbound Telnet session can be established.
Default
5
Format
session-limit <0-5>
Mode
Line Config
6.3.5.1
no session-limit
This command sets the maximum number of simultaneous outbound Telnet sessions to
the default value.
Format
no session-limit
Mode
Line Config
6.3.6
session-timeout
This command sets the Telnet session timeout value.The timeout value unit of time is
minutes. A value of 0 indicates that a session remains active indefinitely.
Default
0
Format
session-timeout <0-160>
Mode
Line Config