7 telnetcon maxsessions, 8 telnetcon timeout, Telnetcon maxsessions - 9 – Kontron AT8902 Full Size CLI User Manual
Page 249: Telnetcon timeout - 9

AT8901/2/3
Management Commands
Page 6 - 9
AT8901/2/3 CLI Reference Manual
6.3.6.1
no session-timeout
This command sets the Telnet session timeout value to the default. The timeout value
unit of time is minutes.
Format
no session-timeout
Mode
Line Config
6.3.7
telnetcon maxsessions
This command specifies the maximum number of Telnet connection sessions that can be
established. A value of 0 indicates that no Telnet connection can be established. The
range is 0-5.
Default
5
Format
telnetcon maxsessions <0-5>
Mode
Privileged EXEC
6.3.7.1
no telnetcon maxsessions
This command sets the maximum number of Telnet connection sessions that can be
established to the default value.
Format
no telnetcon maxsessions
Mode
Privileged EXEC
6.3.8
telnetcon timeout
This command sets the Telnet connection session timeout value, in minutes. A session
is active as long as the session has not been idle for the value set. The time is a decimal
value from 1 to 160.
NOTE: When you change the timeout value, the new value is applied to all
active and inactive sessions immediately. Any sessions that have been
idle longer than the new timeout value are disconnected immediately.
Default
5
Format
telnetcon timeout <1-160>
Mode
Privileged EXEC
6.3.8.1
no telnetcon timeout
This command sets the Telnet connection session timeout value to the default.
NOTE: Changing the timeout value for active sessions does not become effec-
tive until the session is reaccessed. Also, any keystroke activates the
new timeout duration.
Format
no telnetcon timeout
Mode
Privileged EXEC