Kontron AT8902 Full Size CLI - Manual (Page 31)

AT8901/2/3 Using the Command-Line Interface
Page 1 - 7 AT8901/2/3 CLI Reference Manual
Global Config From the Privileged EXEC mode, enter
configure .
To exit to the Privileged
EXEC mode, enter
exit , or
press Ctrl-Z.
VLAN Config From the Privileged EXEC mode, enter
vlan database .
To exit to the Privileged
EXEC mode, enter
exit , or
press Ctrl-Z.
Interface Config From the Global Config mode, enter
interface < unit/slot/port > or
interface loopback or
interface tunnel or
To exit to the Global Config
mode, enter
exit . To return
to the Privileged EXEC
mode, enter Ctrl-Z.
Line Config From the Global Config mode, enter
lineconfig .
To exit to the Global Config
mode, enter
exit . To return
to the Privileged EXEC
mode, enter Ctrl-Z.
Policy-Map
Config From the Global Config mode, enter
policy-map .
To exit to the Global Config
mode, enter
exit . To return
to the Privileged EXEC
mode, enter Ctrl-Z.
Policy-Class-
Map Config From the Policy Map mode enter
class .
To exit to the Policy Map
mode, enter
exit . To return
to the Privileged EXEC
mode, enter Ctrl-Z.
Class-Map
Config From the Global Config mode, enter
class-map .
To exit to the Global Config
mode, enter
exit . To return
to the Privileged EXEC
mode, enter Ctrl-Z.
Router OSPF
Config From the Global Config mode, enter
router ospf .
To exit to the Global Config
mode, enter
exit . To return
to the Privileged EXEC
mode, enter Ctrl-Z.
Router RIP
Config From the Global Config mode, enter
router rip .
To exit to the Global Config
mode, enter
exit . To return
to the Privileged EXEC
mode, enter Ctrl-Z.
MAC Access-list
Config From the Global Config mode, enter
mac access-list extended
.
To exit to the Global Config
mode, enter
exit . To return
to the Privileged EXEC
mode, enter Ctrl-Z.
TACACS Config From the Global Config mode, enter
tacacs-server host ,
where is the IP address of
the TACACS server on your network.
To exit to the Global Config
mode, enter
exit . To return
to the Privileged EXEC
mode, enter Ctrl-Z.
DHCP Pool
Config From the Global Config mode, enter
ip dhcp pool .
To exit to the Global Config
mode, enter
exit . To return
to the Privileged EXEC
mode, enter Ctrl-Z.
Table 6. CLI Mode Access and Exit
Command
Mode
Access Method
Exit or Access Previous
Mode