Kontron AT8902 Full Size CLI - Manual (Page 140)

AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 3 - 28
3.7.14.1 no area stub no-summary
This command configures the default Summary LSA mode for the stub area identified
by
<areaid>
.
Format no area stub no-summary
Mode Router OSPF Config
3.7.15 area virtual-link (OSPF)
This command creates the OSPF virtual interface for the specified
<areaid>
and
<neighbor> . The <neighbor> parameter is the Router ID of the neighbor.
Format
area virtual-link
Mode Router OSPF Config
3.7.15.1 no area virtual-link
This command deletes the OSPF virtual interface from the given interface, identified
by
<areaid>
and
<neighbor>
. The
<neighbor>
parameter is the Router ID of the
neighbor.
Format no area virtual-link
Mode Router OSPF Config
3.7.16 area virtual-link authentication
This command configures the authentication type and key for the OSPF virtual
interface identified by
> and <neighbor> . The <neighbor> parameter is the
Router ID of the neighbor. The value for
<type>
is either none, simple, or encrypt.
The
[key]
is composed of standard displayable, non-control keystrokes from a
Standard 101/102-key keyboard. The authentication key must be 8 bytes or less if the
authentication type is simple. If the type is encrypt, the key may be up to 256 bytes.
Unauthenticated interfaces do not need an authentication key. If the type is encrypt, a
key id in the range of 0 and 255 must be specified.The default value for authentication
type is none. Neither the default password key nor the default key id are configured.
Default none
Format
area virtual-link authentication
{none | {simple } | {encrypt }}
Mode Router OSPF Config
3.7.16.1 no area virtual-link authentication
This command configures the default authentication type for the OSPF virtual interface
identified by
<areaid>
and
<neighbor>
. The
<neighbor>
parameter is the Router ID
of the neighbor.
Format no area virtual-link authentication
Mode Router OSPF Config