Kontron AT8902 Full Size CLI - Manual (Page 266)

Management Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 6 - 26
Format
radius server host {auth | acct} []
Mode Global Config
6.8.2.1 no radius server host
This command is used to remove the configured RADIUS authentication server or the
RADIUS accounting server. If the 'auth' token is used, the previously configured
RADIUS authentication server is removed from the configuration. Similarly, if the
'acct' token is used, the previously configured RADIUS accounting server is removed
from the configuration. The
parameter must match the IP address of the
previously configured RADIUS authentication / accounting server.
Format
no radius server host {auth | acct}
Mode Global Config
6.8.3 radius server key
This command is used to configure the shared secret between the RADIUS client and
the RADIUS accounting / authentication server. Depending on whether the 'auth' or
'acct' token is used, the shared secret is configured for the RADIUS authentication or
RADIUS accounting server. The IP address provided must match a previously
configured server. When this command is executed, the secret is prompted.
NOTE: The secret must be an alphanumeric value not exceeding 16 charac-
ters.
Format
radius server key {auth | acct}
Mode Global Config
6.8.4 radius server msgauth
This command enables the message authenticator attribute for a specified server.
Format
radius server msgauth
Mode Global Config
6.8.4.1 no radius server msgauth
This command disables the message authenticator attribute for a specified server.
Format
no radius server msgauth
Mode Global Config
6.8.5 radius server primary
This command is used to configure the primary RADIUS authentication server for this
RADIUS client. The primary server handles RADIUS requests. The remaining
configured servers are only used if the primary server cannot be reached. You can
configure up to three servers on each client. Only one of these servers can be
configured as the primary. If a primary server is already configured prior to this
command being executed, the server specified by the IP address specified used in this