Kontron AT8902 Full Size CLI - Manual (Page 142)

AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 3 - 30
3.7.19.1 no area virtual-link retransmit-interval
This command configures the default retransmit interval for the OSPF virtual interface
on the virtual interface identified by
<areaid>
and
<neighbor>
. The
<neighbor>
parameter is the Router ID of the neighbor.
Format no area <areaid> virtual-link <neighbor> retransmit-
interval
Mode Router OSPF Config
3.7.20 area virtual-link transmit-delay (OSPF)
This command configures the transmit delay for the OSPF virtual interface on the
virtual interface identified by
<areaid>
and
<neighbor>
. The
<neighbor>
parameter
is the Router ID of the neighbor. The range for seconds is 0 to 3600 (1 hour).
Default 1
Format
area <areaid> virtual-link <neighbor> transmit-delay
<seconds>
Mode Router OSPF Config
3.7.20.1 no area virtual-link transmit-delay
This command resets the default transmit delay for the OSPF virtual interface to the
default value.
Format no area <areaid> virtual-link <neighbor> transmit-delay
Mode Router OSPF Config
3.7.21 default-information originate (OSPF)
This command is used to control the advertisement of default routes.
Default metric—unspecified
type—2
Format
default-information originate [always] [metric <0-
16777214>] [metric-type {1 | 2}]
Mode Router OSPF Config
3.7.21.1 no default-information originate (OSPF)
This command is used to control the advertisement of default routes.
Format
no default-information originate [metric] [metric-type]
Mode Router OSPF Config
3.7.22 default-metric (OSPF)
This command is used to set a default for the metric of distributed routes.
Format default-metric <1-16777214>
Mode Router OSPF Config