Rockwell Automation CHPS-250 Linear Stage Installation - Manual (Page 14)

14 Rockwell Automation Publication CHPS-UM001D-EN-P - July 2014
Chapter 1 Stage Safety
Air Freight Transportation When air freighting stages special preparations and precautions must be taken.
The following information outlines the basic requirements at the publication
date of this document. However, regulations are subject to change and additional
area or carrier restrictions can be imposed. Check with your carrier or logistics
specialist regarding current local, regional, and national transportation
requirements when shipping this product.
The 200 mm or a 250 mm stages contain magnetized material, as classified by
International Air Transport Association (IATA) Dangerous Goods Regulations.
An IATA trained individual must be involved when shipping this product via
domestic or international air freight. Packing Instruction 902 provides
information regarding the preparation of this product for air transportation.
Follow these regulations for general marking and labeling requirements, the
application of Magnetized Material Handling Labels, and instructions for
preparing the Shipper's Declaration for Dangerous Goods.
As a minimum, refer to the following IATA Dangerous Goods Regulations:
• Subsection 1.5: Training
• Subsection 3.9.2.2: Classification as Magnetized Material
• Subsection 4.2: Identification as UN 2807, Magnetized Material, Class 9,
Packing Instruction 902
• Subsection 7.1.5: Marking
• Subsection 7.2: Labeling
• Subsection 7.4.1: Magnetized Material Label
• Section 8: Shipper’s Declaration for Dangerous Goods
When shipped via ground in the United States, these products are not considered
a U.S. D.O.T. Hazardous Material and standard shipping procedures apply.
Standards Standards and requirements applicable to this product include, but are not
limited to, the following:
• ANSI/RIA R15.06, Industrial Robots and Robot Systems Safety
Requirements - Teaching Multiple Robots
• ANSI/NFPA 79, Electrical Standard for Industrial Machinery
• CSA/CAN Z434, Industrial Robots and Robot Systems- General Safety
Requirements
• EN60204-1, Safety of Machinery. Electrical Equipment of Machines
Motor Model Identification The nameplate lists the motor model for the stage.