Rockwell Automation 2097-Vxxx Kinetix 300 EtherNet/IP Indexing Servo Drive User Manual - Manual (Page 25)

Rockwell Automation Publication 2097-UM001D-EN-P - November 2012 25
Installing the Kinetix 300 Drive System Chapter 2
Minimum Clearance Requirements
This section provides information to assist you in sizing your cabinet and
positioning your Kinetix 300 system components.
Figure 2 illustrates minimum clearance requirements for proper airflow and
installation:
• Additional clearance is required depending on the accessory items
installed.
• An additional 9.7 mm (0.38 in.) clearance is required left of the drive if the
I/O expansion terminal block is used.
• An additional 26 mm (1.0 in.) clearance is required right of the drive when
the heatsink is present.
• An additional 36 mm (1.42 in.) is required right of the drive when the
side-mount line filter is present. An additional 50 mm (2.0 in.) is required
behind the drive when the rear-mount line filter is present.
• An additional 5.0 mm (0.19 in.) clearance is required in front of the drive
when the 2090-K2CK-D15M feedback connector kit is used.
• Additional clearance is required for the cables and wires connected to the
top, front, and bottom of the drive.
• An additional 150 mm (6.0 in.) is required when the drive is mounted
adjacent to noise sensitive equipment or clean wireways.
See Kinetix Servo Drives Specifications Technical Data, publication
GMC -TD003 for Kinetix 300 drive dimensions.
Figure 2 - Minimum Clearance Requirements
IMPORTANT Mount the module in an upright position as shown. Do not mount the drive
module on its side.
00 300
A
25.0 mm (1.0 in.) Clearance
for Airflow and Installation
3 mm (0.12 in.)
Side Clearance 3 mm (0.12 in.)
Side Clearance
25.0 mm (1.0 in.) Clearance
for Airflow and Installation
Drive
Cat. No. A
2097-V31PR0 185 (7.29)
2097-V31PR2 185 (7.29)
2097-V32PR0 230 (9.04)
2097-V32PR2 230 (9.04)
2097-V32PR4 230 (9.04)
2097-V33PR1 185 (7.29)
2097-V33PR3 185 (7.29)
2097-V33PR5 185 (7.29)
2097-V33PR6 230 (9.04)
2097-V34PR3 185 (7.29)
2097-V34PR5 185 (7.29)
2097-V34PR6 230 (9.04)