Rockwell Automation 1755-OF8 GuardPLC Controller Systems - Manual (Page 135)

Publication 1753-UM001C-EN-P - March 2010 135
Use the Control Panel to Monitor Status Chapter 14
Control Panel Resource
Menu To modify the safety settings of the controller, choose Safety from the
control panel’s Resource menu .
IMPORTANT
Any settings you change via the Resource menu are directly
updated in the controller and are saved in the project.
Menu Item Description
Check Consistency Compares the program running in the controller with the program you are editing in
RSLogix Guard PLUS! software. If they match, your offline project has previously been
downloaded to the GuardPLC controller.
Set Main Enable Lets safety parameters be changed. You can only choose Set Main Enable when the
controller is in Stop mode.
For more information, see page 119 .
Reset Main Enable Prevents safety parameters from being changed.
For more information, see page 119 .
Change Safety Parameters Changes the safety parameters, if Set Main Enable is activated.
You must have Read/Write or Administrator access to be able to change safety
parameters.
For more information about these parameters, see page 119 .
TIP
Refer to the Using RSLogix Guard PLUS! Software with
GuardPLC Controllers Programming Manual, publication
1753-PM001 , for more information on the Warmstart, Coldstart,
Stop, and Download menu items.