Rockwell Automation 1336T PLC Comm. Adapter, Series B, FRN 2.xx-3.xx - Manual (Page 129)

6–39
Publication 1336 FORCE–5.13 –– September, 1998
426 Channel A Remote I/O Warning Select
[ChA RIOA Warn Sel] –– adapter mode
[ChA RIOS Warn Sel] –– scanner mode
ChA RIOx Warn Sel dictates whether the PLC
Communications Adapter Board will report a
warning condition if a PLC controller RIO
communications fault occurs at channel A.
ChA RIOx Warn Sel is not used if channel A is set
up for DH+ communications.
Parameter Number 426
Parameter Type Read/Write, Non–Linkable Sink
Display Units / Drive Units Bits
Factory Default 15
Minimum Value 0
Maximum Value 15 (adapter) or 255 (scanner)
File – Group Diagnostics – Fault Select/Status
Communications I/O – Fault Select/Status
When RIO adapter is used:
Enums
Bits 7–4 Bit 3 Bit 2 Bit 1 Bit 0
Res/Pgm/Test (Flt 36023)
0 = No drive soft fault
1 = Drive soft fault
Comm Loss (Flt 36021)
0 = No drive soft fault
1 = Drive soft fault
Last State
0 = Data zeroed
1 = Last state
Rack Inhibit (Flt 36025)
0 = No drive soft fault
1 = Drive soft fault
Not used
When RIO scanner is used:
Enums
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Rck Flt Grp 0
0 = No rack fault
1 = Rack fault
Rck Flt Grp 2
0 = No rack fault
1 = Rack fault
Rck Flt Grp 4
0 = No rack fault
1 = Rack fault
Rck Flt Grp 6
0 = No rack fault
1 = Rack fault
Inhibit Grp 0
0 = Group 0 not inhibited
1 = Inhibit group 0
Inhibit Grp 2
0 = Group 2 not inhibited
1 = Inhibit group 2
Inhibit Grp 4
0 = Group 4 not inhibited
1 = Inhibit group 4
Inhibit Grp 6
0 = Group 6 not inhibited
1 = Inhibit group 6