Rockwell Automation 1336T PLC Comm. Adapter, Series B, FRN 2.xx-3.xx - Manual (Page 113)

6–23
Publication 1336 FORCE–5.13 –– September, 1998
353 Channel A Remote I/O Output 2
[ChA RIOA Out 2] –– adapter mode
[ChA/B RIOA Out2] –– adapter mode with redundancy
[ChA RIOS Out 2] –– scanner mode
ChA RIOx Out 2 contains the third word or data
group to the PLC controller input image table. The
data is transferred to the PLC controller every rack
scan. The PLC Communications Adapter Board can
provide this value directly. Other drive functions can
provide this value through a configuration link.
Parameter Number 353➀
Parameter Type Read/Write, Sink
Display Units / Drive Units None
Factory Default None
Minimum Value –32767
Maximum Value +32767
File – Group Communications I/O – Channel A
➀ This parameter is not available if you set up channel A for DH+. Availability also
depends on the selected rack size.
Note: All eight words are displayed regardless of the rack size. Only the number of words corresponding to the rack size and protocol
(with or without block transfer) are functional.
354 Channel A Remote I/O Output 3
[ChA RIOA Out 3] –– adapter mode
[ChA/B RIOA Out3] –– adapter mode with redundancy
[ChA RIOS Out 3] –– scanner mode
ChA RIOx Out 3 contains the fourth word or data
group to the PLC controller input image table. The
data is transferred to the PLC controller every rack
scan. The PLC Communications Adapter Board can
provide this value directly. Other drive functions can
provide this value through a configuration link.
Parameter Number 354➀
Parameter Type Read/Write, Sink
Display Units / Drive Units None
Factory Default None
Minimum Value –32767
Maximum Value +32767
File – Group Communications I/O – Channel A
➀ This parameter is not available if you set up channel A for DH+. Availability also
depends on the selected rack size.
Note: All eight words are displayed regardless of the rack size. Only the number of words corresponding to the rack size and protocol
(with or without block transfer) are functional.
355 Channel A Remote I/O Output 4
[ChA RIOA Out 4] –– adapter mode
[ChA/B RIOA Out4] –– adapter mode with redundancy
[ChA RIOS Out 4] –– scanner mode
ChA RIOx Out 4 contains the fifth word or data
group to the PLC controller input image table. The
data is transferred to the PLC controller every rack
scan. The PLC Communications Adapter Board can
provide this value directly. Other drive functions can
provide this value through a configuration link.
Parameter Number 355➀
Parameter Type Read/Write, Sink
Display Units / Drive Units None
Factory Default None
Minimum Value –32767
Maximum Value +32767
File – Group Communications I/O – Channel A
➀ This parameter is not available if you set up channel A for DH+. Availability also
depends on the selected rack size.
Note: All eight words are displayed regardless of the rack size. Only the number of words corresponding to the rack size and protocol
(with or without block transfer) are functional.