Rockwell Automation 1336T PLC Comm. Adapter, Series B, FRN 2.xx-3.xx - Manual (Page 102)

6–12
Publication 1336 FORCE–5.13 –– September, 1998
300 Adapter ID
[Adapter ID]
Adapter ID displays the identifier for the PLC
Communications Adapter Board.
Parameter Number 300
Parameter Type Read Only, Source
Display Units / Drive Units None
Factory Default 1
Minimum Value 1
Maximum Value 1
File – Group Diagnostics – Info
301 Adapter Version
[Adapter Version]
Adapter Version displays the current firmware
version of the PLC Communications Adapter Board.
Parameter Number 301
Parameter Type Read Only, Source
Display Units / Drive Units None
Factory Default 2.XX
Minimum Value 0.00
Maximum Value 9.99
File – Group Diagnostics – Info
302 SCANport Communications Retries
[SP Comm Retries]
SP Comm Retries counts the number of
communication retries for all entries in the SCANport
scan list.
Parameter Number 302
Parameter Type Read, Source
Display Units / Drive Units None
Factory Default 0
Minimum Value 0
Maximum Value 65535
File – Group Diagnostics – Info
303 Channel A DIP Switch
[ChA DIP Switch]
ChA DIP Switch displays the current DIP switch
settings for Channel A of the PLC Communications
Adapter Board. The two groups of numbers on the
left represent block U2, and the two groups on the
right represent block U3.
Parameter Number 303
Parameter Type Read Only, Source
Display Units / Drive Units Bits
Factory Default 0000 0000 0000 0000
Minimum Value 0000 0000 0000 0000
Maximum Value 1111 1111 1111 1111
File – Group Diagnostics – Info
304 Channel B DIP Switch
[ChB DIP Switch]
ChB DIP Switch displays the current DIP switch
settings for Channel B of the PLC Communications
Adapter Board. The two groups of numbers on the
left represent block U4, and the two groups on the
right represent block U5.
Parameter Number 304
Parameter Type Read Only, Source
Display Units / Drive Units Bits
Factory Default 0000 0000 0000 0000
Minimum Value 0000 0000 0000 0000
Maximum Value 1111 1111 1111 1111
File – Group Diagnostics – Info
305 Channel A LED State
[ChA LED State]
ChA LED State displays the current LED state for
channel A. The LED states correspond to LEDs D8,
D10, and D12 on the PLC Communications Adapter
Board.
Parameter Number 305
Parameter Type Read Only, Source
Display Units / Drive Units None
Factory Default 0
Minimum Value 0
Maximum Value 5
File – Group Diagnostics – Info
Enums 0 = Off 1 = Red 2 = Green
3 = Yellow 4 = Flash Green 5 = Flash Red