Rockwell Automation 1336T PLC Comm. Adapter, Series B, FRN 2.xx-3.xx - Manual (Page 110)

6–20
Publication 1336 FORCE–5.13 –– September, 1998
337 Channel B Remote I/O Input 7
[ChB RIOA In 7] –– adapter mode
[ChB RIOS In 7] –– scanner mode
ChB RIOx In 7 contains the eighth word or data
group from the PLC controller output image table.
The RIO scanner transfers the data to the drive
every rack scan. The PLC Communications Adapter
Board can use this value directly. Other drive
functions can use this value through a configuration
link.
Parameter Number 337➀
Parameter Type Read Only, Source
Display Units / Drive Units None
Factory Default None
Minimum Value –32767
Maximum Value +32767
File – Group Communications I/O – Channel B
➀ This parameter is not available if you set up channel B for DH+. Availability also
depends on the selected rack size.
Note: All eight words are displayed regardless of the rack size. Only the number of words corresponding to the rack size and protocol
(with or without block transfer) are functional.
338 SCANport Analog Input
[SP Analog In]
SP Analog In converts a +10V analog input value to
a +32767 value. You can then link this digital value
to one of the 1336 FORCE input parameters.
Parameter Number 338
Parameter Type Read Only, Sink
Display Units / Drive Units None
Factory Default None
Minimum Value –32767
Maximum Value +32767
File – Group Communications I/O – Analog Input
339 Analog Input 1
[Analog In 1]
Analog In 1 displays the result of converting a
±
10V
signal to a
±
32767 value using Analog In 1 Scale
(parameter 393) and Analog In 1 Offset (parameter
392). You can link this digital value to other 1336
FORCE parameters.
Parameter Number 339
Parameter Type Read Only, Source
Display Units / Drive Units None
Factory Default 0
Minimum Value –32767
Maximum Value +32767
File – Group Communications I/O – Analog Input
340 Analog Input 2
[Analog In 2]
Analog In 2 displays the result of converting a
±
10V
signal to a
±
32767 value using Analog In 2 Scale
(parameter 395) and Analog In 2 Offset (parameter
394). You can link this digital value to other 1336
FORCE parameters.
Parameter Number 340
Parameter Type Read Only, Source
Display Units / Drive Units None
Factory Default 0
Minimum Value –32767
Maximum Value +32767
File – Group Communications I/O – Analog Input
341 Analog Input 3
[Analog In 3]
Analog In 3 displays the result of converting a
±
10V
signal to a
±
32767 value using Analog In 3 Scale
(parameter 397) and Analog In 3 Offset (parameter
396). You can link this digital value to other 1336
FORCE parameters.
Parameter Number 341
Parameter Type Read Only, Source
Display Units / Drive Units None
Factory Default 0
Minimum Value –32767
Maximum Value +32767
File – Group Communications I/O – Analog Input