2 parameter list, C00002 | device commands, Parameter list – Lenze 8400 BaseLine D User Manual
Page 171: Code, C002, C002/1, Mmand, C002/x, Thes, C003
Lenze · 8400 BaseLine D · Reference manual · DMS 5.5 EN · 01/2014 · TD05
171
9
Parameter reference
9.2
Parameter list
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
9.2
Parameter list
This chapter lists all parameters of the operating system in numerically ascending order.
C00002
Note!
The parameter descriptions are based on the software version V03.04.00.
Parameter | Name:
C00002 | Device commands
Data type: UNSIGNED_8
Index: 24573
d
= 5FFD
h
Note:
• Before switching off the supply voltage after carrying out a device command, check whether the device com-
mand has been carried out successfully via the status display under
!
• Before activating the device commands through a master control, please wait for the "ready" message of the
controller.
• The device will reject a write process to C00002/x if the value is >1 and issue an error message.
:
Selection list
0 Off / ready
1 On / start
2 Work in progress
4 Action cancelled
5 No access
6 No access controller inhibit
Subcodes
Lenze setting
Info
C00002/1
0: Off / ready
Load Lenze setting
• All parameters are reset to the Lenze setting.
• Only possible when the controller is inhibited.
C00002/2
0: Off / ready
Load parameter set 1
• Load parameter set 1 from the memory module.
C00002/3
0: Off / ready
Reserved
C00002/4
0: Off / ready
Reserved
C00002/5
0: Off / ready
Reserved
C00002/6
0: Off / ready
Reserved
C00002/7
0: Off / ready
Save parameter set 1
• Saving parameter set 1 in the memory module safe
against mains failure.
C00002/8
0: Off / ready
Reserved
C00002/9
0: Off / ready
Reserved
C00002/10
0: Off / ready
Reserved
C00002/11
0: Off / ready
Save all parameter sets
• All parameter sets are saved in the memory module
with mains failure protection.
C00002/12
0: Off / ready
Import EPM data
• Setting "1: On / start" activates the automatic import
of parameters of the memory module after the error
message "PS04".