7drive application – Lenze 8400 BaseLine D User Manual
Page 129
Lenze · 8400 BaseLine D · Reference manual · DMS 5.5 EN · 01/2014 · TD05
129
7
Drive application
7.2
Interface description
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
bSetQuickstop
BOOL
Enable quick stop (QSP)
• Also see device command "
Activate/Deactivate quick stop
".
TRUE Activate quick stop
• The motor control is decoupled from the setpoint selection and
within the deceleration time parameterised in
the motor is
brought to a standstill (n
ist
= 0).
• The motor is kept at a standstill during closed-loop operation.
• A pulse inhibit (CINH) is set if the "Auto-DCB" function has been
activated via
FALSE Deactivate quick stop
• The quick stop is deactivated if no other source for the quick stop
is active.
•
provides a bit coded representation of all active sources/
triggers of a quick stop..
bSetDCBrake
BOOL
Manual DC-injection braking (DCB)
• Detailed information on DC-injection braking is provided in the motor control,
".
Note!
Holding braking is not possible when this braking mode is used!
FALSE Deactivate DC-injection braking.
TRUE Activate DC-injection braking, i.e. the drive is brought to a standstill
by means of DC-injection braking.
• The braking effect stops when the rotor is at standstill.
• After the hold time (
) has expired, the controller sets the pul-
se inhibit (CINH).
Fail-safe selection of the direction of rotation in connection with quick stop
• In control mode "Terminals 16", both inputs are connected to the digital terminals DI3 and DI4.
• For a detailed functional description see FB
bRLQCw
BOOL
Activate clockwise rotation (fail-safe)
FALSE Quick stop
TRUE Clockwise rotation
bRLQCcw
BOOL
Activate counter-clockwise rotation (fail-safe)
FALSE Quick stop
TRUE Counter-clockwise rotation
Identifier
Data type
Configuration parameters
Information/possible settings