ETC Unison Paradigm ACP Configuration Manual v2.1.2 - Manual (Page 53)

3
Programming 48
Step 2: Use the touch wheel to scroll to Power On Behavior “Mode” and press enter
(
). Follow the on screen choices to make an action selection.
DMX Settings
The DMX Settings menu displays the direction, activity and refresh rate settings for both
DMX port A and DMX port B. These settings are contained in the architectural configuration
and may be configured using LightDesigner.
• Port activity is determined by the traffic through each port. The display may read active
or inactive.
• Refresh rate is the only user-selectable setting within this menu. When a DMX port is
set to input or disabled, the refresh rate is not selectable or changeable. Refresh rate
settings do not affect updates to streaming sACN outputs data.
• The “Best/Auto” setting is default and allows the application to determine the
refresh rate of output DMX to optimize frame sends.
• The “Slow 31Hz”, “Med 35Hz”, “Fast 41Hz”, and “Max 44Hz” yield pre-configured
DMX timing and are provided as tools to assist in compatibility issues with DMX
receiving devices that require a specific setting.
Step 1: Use the touch wheel to scroll to “DMX Settings” from within the “Arch Setup”
menu. DMX Settings displays with Port A Refresh selected.
Step 2: Select the desired port and press enter ( ) repeatedly to cycle through the
available refresh rate options.
Step 3: Press enter ( ) repeatedly to cycle through the available refresh rate options.
DMX Settings
Port A: Input
Inactive
Refresh: NA
Port B: Output
Active
Refresh: Best/Auto
• DMX Port A and Port B settings include, input, output, or
disabled. When the Paradigm ACP is hosted in a DRd rack,
port B defaults to output DMX and cannot be changed.