Preferences, Click volume – ETC Unison Paradigm ACP Configuration Manual v2.1.2 User Manual
Page 50
45
Paradigm Architectural Control Processor Configuration Manual
the proper “Time Zone” based on hours offset from GMT (Greenwich Mean
Time) and press enter. Visit
http://wwp.greenwichmeantime.com/
for a
complete listing of GMT time zones. The selection moves back to the “Time
Zone” menu list.
Step 7:
Change “Latitude” and “Longitude” to set your accurate location. By default,
latitude is set directionally North, although you may change the selection to
South as required. By default, longitude is set directionally West, although you
may change the selection to East as required. This setting is contained in the
architectural configuration.
a: Scroll to “Latitude” selection in the menu list and press enter (
).
b: Scroll to select the desired angle (degrees), minutes, and direction (N or S),
pressing enter (
) for each.
c: Proceed with setting Longitude in the same manner as you have set
Latitude.
Step 8:
Change the “DST” (daylight saving time) so the system retains the correct time.
This value defaults to “US Dates” but can be changed to “EU Dates”, “Manual
Dates”, or “Not Observed”. This setting is contained in the architectural
configuration.
a: Scroll to “DST” selection in the menu list and press enter (
). The selection
toggles to the next option in the list.
b: Continue pressing enter (
) until you reach the desired setting. If “Manual
Dates” is selected, continue to step 9, otherwise skip step 9.
Step 9:
Set “Manual DST Dates” displays in the menu list only when the daylight saving
time setting is set to “Manual Dates”. This settings allows you to manually change
the DST start and end dates.This setting is contained in the architectural
configuration.
a: Scroll to “Manual DST Dates” in the menu list and press enter (
). The
current DST start and end dates are displayed in the “Manual DST Dates”
menu along with “Set Manual DST Dates” selection.
b: Press enter (
) to set manual dates. The menu list displays the DST Start
Date month, day of week, and week of month for user selection. The menu
list also displays the DST End Date month, day of week, and week of month
for user selection.
•
month and day of week are selected by pressing the enter (
) button and
making a selection from a new menu list.
•
week of month is selected by pressing the enter (
) button and cycling
through the selections of “First”, “Second”, “Third”, “Fourth”, and “Last”.
c: Press the back ( ) button when all manual settings are complete.
Preferences
Click Volume
Step 1:
Use the touch wheel to scroll to “Preferences” from within the “Arch Setup” menu
and press enter (
). The Preferences menu list displays.
Click Volume:
Low
Inactivity Time:
1 min
Backlight: Auto
Language:
English
Boot Logo:
On
Preferences
“Preferences” is a menu list of available settings related to the
Paradigm ACP user interface such as the touch wheel’s click
volume, inactivity time setting before the unit sleeps, the
backlight time setting before the backlight dims, and the
language setting for the menu. Preferences stay with the ACP
not the configuration file and therefore only need to be set once.