ETC Unison Paradigm ACP Configuration Manual v2.1.2 - Manual (Page 41)

3
Programming 36
Step 2: Assign a DMX address to the first dimmer in the selection and press enter ( ).
The focus changes back to the dimmer number. When dimmer doubling is
enabled for a selected dimmer, the focus changes to the second address (b)
selection for the affected dimmers.
Step 3: Assign a DMX address to the second address (b) of the dimmer doubled dimmer
in the list and press enter (
) to accept the selection. The focus changes back
to the dimmer number.
Assigning a DMX address to the first selected dimmer automatically assigns consecutive
numbering to the remaining selected dimmers based on the first entry of the selection.
When hi-resolution dimmers are in the selection, the low (L) address of the next dimmer
assumes the next consecutive address number after the high (H) address.
Emergency Setup
The DRd enclosure detects a contact input and immediately triggers the panic/emergency
preset prior to processing any control levels, regardless of the condition of the enclosure
(physical, configuration, or firmware).
Emergency operation uses the emergency settings that are provided by the dimming
engine, as set in Emergency Setup menu, even if the Paradigm ACP configuration and the
dimming engine configuration do not match.
When panic is triggered in a DRd enclosure, the following menus are not accessible for
view or edit:
• “Dimming Setup” menu
• “Restore Defaults”, “Load Dimming Config”, and “Update Firmware” menus as found in
the “File Operations” menu.
• The [recent] commands shortcut button
N o t e : If a specified DMX address is already assigned
to another dimmer, a dialog will display for your
confirmation.
Select “Yes” to remove the DMX address from
the conflicting dimmer and apply it to the new
dimmer. Select “No” to allow multiple dimmers
to share the same patched DMX address.
1 and 3 thru 6
Mode Dim DMX DMX
1:
100
DD 2: 121a 377b
DD 3: --- a ---b
4: ---
HiRes 5: --- H --- L
6: ---
1 and 3 thru 6
Mode Dim DMX DMX
1:
100
DD 2: 121a 377b
DD 3: ---a 390 b
4: ---
HiRes 5: ---H ---L
6: ---
1 and 3 thru 6
Mode Dim DMX DMX
1: 100
DD 2: 121a 377b
DD 3: 101a 390b
4: 102
HiRes 5: 103H 104L
6: 105
Step 2: Step 3:
Attention:
One or more DMX
addresses are already
in use. Would you
like to unpatch from
the previous dimmers?
Yes
No
Emergency Dimmers
Emergency Level: 100
Load Shedding: On
Input Type: Maintained
Active When: Closed
Emergency Setup
The “Emergency Setup” provides access to the setup and
operation of dimmers when the integrated emergency bypass
operation is triggered. This operation is UL 924 Listed.