ETC Cobalt Family v7.0.0 - Manual (Page 719)

717
3. Press INSERT to create a new Template.
4. Go to TEXT and press MODIFY to enter a name. Press MODIFY again to confirm.
5. Go to Parameters and press MODIFY to open the Template Editor.
6. Press INSERT to create a step. Each step contains the settings for a single parameter - for example,
a pan/tilt effect would have two steps.
See Dynamic Template Editor - Functions .
Dynamic Template Editor - Functions
Column Input Function
Ch.Index [#]
[MODIFY]
0 means all selected channels are affected by this step.
For numbers >0 only channels that match this index
number will be activated. For example "2" means that
only every second channel will be affected (of the
selected channels).
Parameter [MODIFY] Opens a dropdown. Select which parameter this step shall
affect.
Table [MODIFY] Opens a dropdown. Select which table this step should
apply. See Dynamics - Tables .
Delay [MODIFY] A delay in % before the step starts to move
Offset [MODIFY] An Offset in % where in the table this step starts
Size [#]
[MODIFY] See Size & Rate
Rate [#]
[MODIFY] See Size & Rate
Wait [#]
[MODIFY] A wait time, in percent (1- 1000%) for this step before it
is repeated. The Wait time is relative to all other steps.