ETC Cobalt Family v7.0.0 - Manual (Page 591)

589
Device Control - Fetch/Copy
The FAN key in the programming section is used to copy parameter values for devices from any
Preset. Fetching from Presets in the Main Sequence will copy the STATE of those devices including
any tracked values from presets earlier in the Sequence.
1. First select the devices you wish to copy values to.
2. Select function from the table below:
Function Key Feedback
FOCUS values [#] [ON/FETCH] &
[FOCUS] Focus values from Preset #
are copied to the selected
channel(s).
COLOR values [#] [ON/FETCH] &
[COLOR] Color values from Preset #
are copied to the selected
channel(s).
BEAM values [#] [ON/FETCH] &
[BEAM] Beam values from Preset #
are copied to the selected
channel(s).
Parameter values [#] [ON/FETCH] &
[Wheel_Key] Parameter values from
Preset # are copied to the
selected channel(s).
All values [#] [ON/FETCH] &
[ATTRIB] All parameter values from
Preset # are copied to the
selected channel(s).
NOTE
If the Preset specified is in the Main Sequence, you will fetch the ACTUAL
STATE of the attributes in the specified preset. This is not necessarily the
same values that are stored in that preset, since some of them may be
tracking into it from previous presets.
HINT
You can fetch intensity values as well. See
Presets - Fetch Intensities .