ETC Cobalt Family v7.0.0 - Manual (Page 711)

709
A fly out can be done with a Dynamic Effect, but you have no control over the
specific start and end points for each device. Here this is easy to change at
any time by re-recording either of the two focus palettes used..
"An RGB chase"
This can be done with a Content Effect in Continuous mode with three steps, (color palettes "red",
"green", "blue").
In this example Color Palettes are used, although we could have used
absolute values for CMY just as well.
"An intensity ripple chase"
This can be done with a Content Effect in Break mode, with just a Background state (intensity = 0)
and one step (intensity = full).