ETC Cobalt Family v7.0.0 - Manual (Page 180)

178
Play Settings - Introduction
Press SETUP in the programming section to open system settings. You can also open a local settings
popup for any key by holding SETUP and pressing that key (for example GO or RECORD)
The system settings popup contains the following sections
•
LETS BEGIN >A summary of the most important settings.
•
CHANNELS >Configure default values and select Command Syntax.
•
CROSSFADE >Configure default times, fader modes and fade direction.
•
MASTERS >Configure Flash and fade on time and Auto-save master pages.
•
EFFECTS >Configure "Remember Effect Parameters".
•
SYSTEM >Configure Auto-save, rubberband, beep, remote etc.
•
ATTRIBUTES >Configure default times and recording modes.
•
MIDI >Midi Settings
•
SHOW CONTROL >Configure Midi, Show Control and Time Code.