ETC Cobalt Family v7.0.0 User Manual

Page 467

465

Set Channel Levels

Once a channel(s) is selected you can set levels in the following ways.

Level Command

RPN

AT MODE

Set to 50%

[5] [0]
[@LEVEL]

[@LEVEL] [0] [5]

Set to 55%

[5] [5]
[@LEVEL]

[@LEVEL] [5] [5]

Set to 100%

[@LEVEL]
[@LEVEL]

[@LEVEL] [@LEVEL]

Set to 70%*

[@LEVEL]

[@LEVEL] [7]

Set to 0%

[@LEVEL]
[@LEVEL]
[@LEVEL]

[@LEVEL] [@LEVEL]
[@LEVEL]

Set to 0%

[C/Alt] & [-%]

Add 5%

[+%]

Subtract 5%

[-%]

Select ch # and add 5%

[#] [+%]

Select ch # and subtract 5%

[#] [-%]

Increase level by #%

[#] [.] [+%]

not possible in at mode

Diminish level by #%

[#] [.] [-%]

not possible in at mode

Revert to last used level
(Undo)

[ON/FETCH] &
[@LEVEL]

[ON/FETCH] & [@LEVEL]

*This is the Step Level value of the SETUP for the Level key. You can change it by holding SETUP
and pressing @LEVEL.

NOTE
There is a function for setting the last recorded level, and for fetching levels
from any recorded Preset.

See

Presets - Fetch Intensities