ETC Cobalt Family v7.0.0 - Manual (Page 609)

607
Device Recording - Introduction
There are four recording modes for recording device parameters:
• Active (default)
• Changed
• All
• Popup
If only changed Device parameters are recorded it is important to record all parameters (a block cue)
in the beginning of each Sequence. There is a check box for this in the Advanced Tab of the
Recording Popup .
Regardless of these settings it's always possible to record attributes
• All attributes manually
• Selected device(s) only
• Selected device(s) to any Preset
• Set all or selected parameters to Changed (to record as Changed) .
NOTE
IF you are working with Changed, there is a SET CHANGED softkey in the
Devices soft key page of the Main Display that allows you to force the flag
changed for any parameter or parameter group. See
Device Recording -
Modes .