Lenovo ThinkPad R400 - Manual (Page 166)

b. In the right pane, put a check mark next to the operating system for which
this application module is intended to be used. If the application is not
specific to any Windows operating system, you can check all of the boxes.
If the application is specific to an operating system, check only the
operating system that applies.
13. In the Source tab, do the following:
a. In the Source Directory field, type the complete path to the folder that
contains the application files.
Note: In the following step, the fields in the Silent Install Command area
are used for applications that are to be installed through a normal
installation process. If you want to copy the installable files to the
target hard disk instead of installing the application, leave the fields
in the Silent Install Command area blank, and fill in the “Path to
copy installable files” field in the Options tab.
b. In the Silent Install Command area, type the command that is to be used
to install the application in the Command field and any associated
parameters in the Parameters field. For example, your command might be
SETUP.EXE and your parameters might be /S .
Note: The following steps apply to the use of mini-applications.
Mini-applications are useful for creating special folders, cleaning up
registry entries, or performing any other service related to the
installation of the application. For more information about the use
of mini-applications, see “Preparing source files for application
modules and add-on operating-system modules” on page 149.
c. If you have a mini-application contained in this module that needs to run
immediately before the actual application is installed, use the Preinstall
Command area to type the command and parameters associated with
starting the mini-application.
d. If you have a mini-application contained in this module that needs to run
immediately after the actual application is installed, use the Postinstall
Command area to type the command and parameters associated with
starting the mini-application.
14. If you want to assign a filter to the application module, do the following in
the Filters tab:
a. Click the Insert Filter icon. The Add Filter window opens.
b. In the left pane of the Add Filters window, navigate to the folder that
contains the filter you want to add.
c. In the right pane of the Add Filter Window, select filter you want to use;
then click OK . The Add Filter window closes and the filter is added to the
Filters tab.
d. Double-click on the filter you just added. The Edit Parameters window
opens.
e. In the Parameters field, type any parameters required to get the desired
result. For information about the parameters associated with the filters
provided with the ImageUltra Builder program, see the ImageUltra Builder
help system.
f. Click OK .
g. If you assign multiple filters to a module, do one of the following:
v If all filters must be satisfied to install the module, click the All of these
must be true radio button.
152 ImageUltra Builder Version 4.01: User Guide