Festo Контроллер крайних положений SPC11 - Manual (Page 95)

4. Commissioning
4-37
Festo P.BE-SPC11-SYS-EN en 1406e
4.4 Instructions on operation
Warning
Damage may occur if maximum permitted limits, such as
mass loads, mass moments of inertia, swivel frequencies
etc. are exceeded. Make sure that the maximum specified
limits of the drive used are observed (see operating in-
structions for the relevant drive).
Warning
In order to avoid damage due to uncushioned movement
into the end positions:
S Always carry out the teach procedure again after adjust-
ing the fixed stops or when components and tubing have
been replaced.
S Observe the permitted mass load.
Warning
In order to avoid undesired movements of the actuators,
always proceed as follows:
Switching on
S Always switch on first the operating voltage supply and
then the compressed air supply.
Switching off
S Switch off the operating voltage supply and the com-
pressed air supply at the same time or in the following
sequence:
1. compressed air supply
2. operating voltage.