Festo Контроллер крайних положений SPC11 - Manual (Page 39)

3. Installation
3-11
Festo P.BE-SPC11-SYS-EN en 1406e
Drive ( 6 )
Use only the permitted combinations of drives and measuring
systems approved of by Festo for the SPC11.
The drive-valve combinations, cylinder diameters, cylinder
lengths and mass loads permitted for the drive used can be
found in the “Drive-Specific Supplement” manual.
Connect the drive, guide, measuring system and the load free
of play in the direction of movement and flush with each
other.
If necessary, provide a sufficiently large supply of energy in
order to minimise the effects of transverse forces on the posi-
tioning behaviour.
Observe the maintenance intervals specified in the operating
instructions for the drive (see operating instructions for the
cylinder/drive or the guide).