Festo Контроллер крайних положений SPC11 - Manual (Page 53)

3. Installation
3-25
Festo P.BE-SPC11-SYS-EN en 1406e
The operating voltage is supplied together with the circuit for
the inputs/outputs via the 15-pin plug marked with “Control”
(see Fig. 3/14).
Pin 15 (white-yellow): DC +24 V
Pin 14 (brown-green): 0 V
Tolerance:
-10 % to +25 %
Connect a protective conductor with sufficient cross sectional
area to the drive, if this is not mounted on an earthed ma-
chine stand.
The following diagram shows the pin numbering of the
“Control” connection. The pin assignment with core colours
for the original cable KMPV-SUB-D-15-... can be found in the
following section.
1 Pin 1
8 Pin 8
9 Pin 9
aE Pin 15
1
8
9
aE
Fig. 3/14: “Control” connection
Short description of the I/O signals at the Control
connection
The function of the input I4 and outputs O4 and O5 can be
configured (see section 4.2.3). The following tables describe
the factory settings. Further information on the I/O signals
can be found in section 4.4.