Festo Контроллер крайних положений SPC11 - Manual (Page 48)

3. Installation
3-20
Festo P.BE-SPC11-SYS-EN en 1406e
Components for variants 1...4
Identifying
components Requirements Recommendation/type
1V1, 1V2 5/2-way valve
– sliding piston valve with positive cover
– with control air
– with reversible flow direction
– flow rate coordinated to the proportional
directional control valve used (1V3)
For MN1H:
– Type MN1H-5/2-D-1-FR-S-C
– Type MN1H-5/2-D-2-FR-S-C
1V3 Proportional directional control valve type
MPYE-...
– flow matches the drive used (1 A)
For suitable valve-drive combinations, see the
drive-specific supplement for the drive used. Type MPYE-5-...-010B
1V4 Exhaust restrictor with silencer
– specifies the speed at which the drive moves
into the desired end position; adjustable
– with appropriate silencer screwed directly into
the restrictor
– must be fitted near valves 1V1, 1V2.
Type GRLA-...-B with U-...
1R1 Compressed air regulating valve
– with 5 ìm filter cartridge
– standard flow matched to the air requirement
of the connected drive
Requirements see also section 3.2
Type LFR-...-D-5M-...
1G1 Compressed air reservoir (optional)
Requirements see section 3.2 Type CRVZS-...
Fig. 3/11: Components for variants 1...4