Festo Контроллер крайних положений SPC11 - Manual (Page 36)

3. Installation
3-8
Festo P.BE-SPC11-SYS-EN en 1406e
Proportional directional control valve ( 5 )
Arrange the tubing between the valve (MPYE-5-...) and the
drive symmetrically.
Recommendation for linear drives and drives with piston rod:
tubing length = cylinder length.
The diagram below shows as an example the tubing of a
cylinder with an MPYE-5-... when an SPC11 is used.
1
2
1 Proportional directional control valve type MPYE-5-...-...
2 Service unit with 5 μm filter, without lubricator
Fig. 3/2: Pneumatic circuit diagram
Fit the valve in accordance with the operating instructions
supplied with the valve.