Festo Контроллер крайних положений SPC11 - Manual (Page 89)

4. Commissioning
4-31
Festo P.BE-SPC11-SYS-EN en 1406e
In order to teach an intermediate position with the supply
pressure switched on, proceed as follows:
1. Briefly press the button { or } . The teachable position
number (e.g. 3) will then flash.
The position number flashes.
2. If you do not wish to teach the intermediate position
shown, press briefly the ESC button. The process will then
be interrupted. Then repeat step 1. The next teachable
position number will then flash.
Please note
The following function will cause the drive to be set in
motion. Make sure that:
– Nobody can place his/her hand in the positioning range
of the moveable mass, unless the compressed air supply
is switched off.
– The positioning range is free collision contours.
3. If you wish to teach the intermediate position shown, hold
the button { or } pressed down for as long as is re-
quired to move the mass. The mass will then move in the
appropriate direction.
4. Release the button when the mass is to stop moving. The
mass now stands controlled in the current position.
5. Repeat steps 3 and 4 until the moveable mass reaches
the desired position.
The position number flashes.
6. When the moveable mass has reached the desired posi-
tion, confirm with Enter ( > 2 s ), in order to save the posi-
tion. The current position will then be saved as the inter-
mediate position. The appropriate output (O3 or O4)
supplies a 1-signal.