Festo Контроллер крайних положений SPC11 - Manual (Page 9)

Contents and general instructions
VII
Festo P.BE-SPC11-SYS-EN en 1406e
Notes on the use of this manual
This system manual contains basic general information on
operating, fitting, installing and commissioning the SPC11.
This manual refers to the versions listed in the following:
Note
Observe the expanded functions of the previous version.
Type Version New in this version
Soft Stop SPC11-...
– SPC11-POT-TLF
– SPC11-POT-LWG
– SPC11-MTS-AIF-2
– SPC11-MTS-AIF
– SPC11-INC from software status
24.05.05 or Version 1.76
1)
– Optimised control behaviour with
short measuring systems.
– Optimised behaviour with stop
function (see chapter 4.2.4).
Soft Stop SPC11-...
– SPC11-POT-TLF
– SPC11-POT-LWG
– SPC11-MTS-AIF
– SPC11-INC from software status
27.08.04 or Version 1.41
1)
– SPC11-...-TLF
– SPC11-...-LWG
– SPC11-...-AIF
– SPC11-INC
– Fault acknowledgement possible
via input I6 2)
– The following options can be set: 3)
– Output O5 can deliver Ready or
Error signal,
– Input I4 can be used for Stop
signal or Move signal (P.04).
– The following can be switched
off:
– Positioning time monitoring
– Constant adaptation
– Soft end position behaviour
1) Software status (SW) see rating plate; after being switched on, the software version is displayed
briefly.
2) There must be a 0-signal at input Remote (I8).
3) About the o-parameter (see chapter 4.2).
Special information on installing and commissioning the
SPC11 in conjunction with the drive you are using can be
found in the manual “Drive-Specific Supplement”.