Allied Telesis AT-S39 - Manual (Page 57)

AT-S39 User’s Guide
57
MDI
The operating configuration of the port. Possible values are Auto,
MDI, MDI-X. The status Auto indicates that the port is
automatically determining the appropriate MDI or MDI-X setting.
Spd
The operating speed of the port. Possible values are:
10 - 10 Mbps
100 - 100 Mbps
1000 - 1000 Mbps (AT-8024GB switch only)
Dplx
The duplex mode of the port. Possible values are half-duplex and
full-duplex.
PVID
The port VLAN identifier currently assigned to the port.
VlanID
The VLAN identifier of the VLAN in which the port is an untagged
member. This column will not include the VIDs of the VLANs
where the port is a tagged member.
Flow
The flow control setting for the port. Possible values are:
None - No flow control on the port.
Transmit - Flow control only as packets are being transmitted out
the port.
Receive - Flow control only on as packets are being received on
the port.
Both - Flow control for both packets entering and leaving the port.
State
The current operating status of the port. Possible values are:
Forwarding - The port is sending and receiving Ethernet frames.
Disabled - The port has been manually disabled.