Allied Telesis AT-S39 - Manual (Page 149)

AT-S39 User’s Guide
149
Displaying a List of Host Nodes
You can use the AT-S39 software to display a list of the multicast groups
on a switch, as well as the host nodes. To display the list, perform the
following procedure:
1. From the Main Menu, type 5 to select System Config Menu.
2. From the System Configuration Menu, type 7 to select Advanced
Configuration.
3. From the Advanced Configuration window, type 1 to select IGMP
Snooping Configuration.
The IGMP Snooping Configuration window in Figure 40 is
displayed.
4. From the IGMP Snooping Configuration window, type 6 to select
View Multicast Host List.
The View Multicast Host List in Figure 41 is displayed.
Figure 41 View Multicast Hosts List Window
The information in this window is for viewing purposes only. The
columns are defined below:
Multicast Group
The multicast address of the group.
Membership Port
The port(s) on the switch to which one or more host nodes of the
multicast group are connected.
VLAN
The VID of the VLAN in which the port is an untagged member.
Host IP
The IP address(es) of the host node(s) connected to the port.
Allied Telesyn AT-8024 Ethernet Switch
View Multicast Hosts List
Multicast Group Member Port VLAN Host IP
---------------------------------------------
U - Update Display
R - Return to Previous Menu
Enter your selection: