Allied Telesis AT-S39 - Manual (Page 130)

Section II: Local and Telnet Management
130
Displaying MAC Addresses
The management software has two menu selections for displaying the
MAC addresses of a switch. One selection displays both the static and
dynamic MAC addresses while the other displays just the static
addresses.
To display the MAC address table, perform the following procedure:
1. From the Main Menu, type 6 to select MAC Address Tables.
The MAC Address Table menu in Figure 38 is displayed.
Figure 38 MAC Address Table Menu
2. To display both static and dynamic MAC addresses, type 1 to select
Show All MAC Addresses or A to select View MAC Addresses on Base
Ports. The second selection is useful if you are managing an AT-
8024GB switch with GBIC modules installed, and you do not want to
view the MAC addresses learned on the GBIC ports, just the base
ports.
3. To display only static MAC addresses, type 5 to select Show All Static
MAC Addresses.
Allied Telesyn AT-8024 Ethernet Switch
MAC Address Tables
1 - Show all MAC Addresses
2 - Add static MAC Address
3 - Delete MAC Address
4 - Delete all dynamic MAC Addresses
5 - Show all static MAC addresses
6 - View MAC addresses by port
7 - View the port of MAC address
8 - View MAC addresses by VLAN ID
9 - View Multicast MAC Addresses
A - View MAC addresses on base ports (Port 1 to 24)
R - Return to Previous Menu
Enter your selection: