Allied Telesis AT-S39 - Manual (Page 41)

AT-S39 User’s Guide
41
Activating the AT-S39 Software Default Values
The procedure in this section returns all AT-S39 software parameters to
their default values. This procedure also deletes any VLANs that you
have created on the switch.
Note
The AT-S39 software default values can be found in Appendix A,
AT-S39 Default Settings on page 238.
To return the AT-S39 management software to its default settings,
perform the following procedure:
1. From the Main Menu, type 5 to select System Config Menu.
2. From the System Configuration Menu, type 8 to select Reset to
Factory Defaults.
The following prompt is displayed:
Are you sure you want to reset to factory defaults?
[Yes/No] ->
3. Type Y for yes or N for no.
The following prompt is displayed:
Do you want to reset IP, Subnet, and Gateway as well?
[Yes/No] ->
4. If you type Y for yes, all switch parameters including the IP address,
subnet mask, and gateway address are changed to their default
values. If you type N for no, all switch parameters excluding the IP
address, subnet mask, and gateway address are changed to their
default values.
The following prompt is displayed:
The factory defaults take effect only after the
switch reboots.
Do you want to reboot the switch now? [Yes/No] ->
5. Type Y to reset the switch.
The operating parameters are returned to their default values and
the switch is reset.