Allied Telesis AT-S39 - Manual (Page 39)

AT-S39 User’s Guide
39
Configuring SNMP Community Strings and Trap IP Addresses
To configure the SNMP community strings for the switch and to assign
up to four IP addresses of management stations to receive traps from
the switch, perform the following procedure:
1. From the Main Menu, type 5 to select System Config Menu.
2. From the System Configuration Menu, type 7 to select Advanced
Configuration.
The Advanced Configuration window in Figure 5 is displayed.
Figure 5 Advanced Configuration Window
3. From the Advanced Configuration window, type 3 to select SNMP
Configuration. The SNMP Configuration window in Figure 6 is
displayed.
Figure 6 SNMP Configuration Window
Allied Telesyn AT-8024 Ethernet Switch
Advanced Configuration Menu
1 - IGMP Snooping Configuration
2 - Broadcast Timers Setup
3 - SNMP Configuration
R - Return to Previous Menu
Enter your selection:
Allied Telesyn AT-8024 Ethernet Switch
SNMP Configuration
1 - GET Community .............. public
2 - SET Community .............. private
3 - Trap Community ............. public
4 - Trap Receiver 1 ............ 0.0.0.0
5 - Trap Receiver 2 ............ 0.0.0.0
6 - Trap Receiver 3 ............ 0.0.0.0
7 - Trap Receiver 4 ............ 0.0.0.0
S - Save Configuration Changes
R - Previous Menu
Enter your selection: