Allied Telesis AT-S39 - Manual (Page 184)

Section III: Web Browser Management
184
Configuring the SNMP Parameters and Trap IP Addresses
To change the switch’s SNMP community strings or to specify the IP
addresses of management stations to receive traps from the switch,
perform the following procedure:
1. From the Home page, select Configuration.
2. From the Configuration menu, select System.
3. Select the SNMP tab.
The SNMP window in Figure 56 is displayed.
Figure 56 SNMP Tab
4. Adjust the parameters as desired. The parameters are described
below.
GET Community
SET Community
Trap Community
Use these parameters to set a switch’s SNMP community strings.